REACTIVE POWER COMPENSATION USING UPFC ASSIGNMENT HELP

Get Expert Help on Report Writing

ABSTRACT

Reactive power is an inherent part of the total power. Reactive power is either generated or consumed in almost every component of the system, generation, transmission, and distribution and eventually by the loads. The impedance of a branch of a circuit in an AC system consists of two components, resistance and reactance. Reactance can be either inductive or capacitive, which contribute to reactive power in the circuit. Most of the loads are inductive, and must be supplied with lagging reactive power. It is economical to supply this reactive power closer to the load in the distribution system.

Flexible AC transmission system (FACTS) devices uses power electronics components to maintain controllability and capability of electrical power system. FACTS controller includes Unified Power Flow Controller (UPFC), Static synchronous compensators (STATCOMs), Thyristor controlled series compensators (TCCs), Static series synchronous compensators (SSSCs) and Static VAR compensators (SVCs), are able to modify voltage, phase angle and impedance at particular bus in a power system. UPFC is the most versatile and complex power electronic equipment that has emerged for the control and optimization of power flow in electrical power transmission system. In this paper we see how the UPFC increases the transmission capacity.

1. INTRODUCTION

Power Generation and Transmission is a complex process, requiring the working of many components of the power system in tandem to maximize the output. One of the main components to form a major part is the reactive power in the system. It is required to maintain the voltage to deliver the active power through the lines. Loads like motor loads and other loads require reactive power for their operation. To improve the performance of ac power systems, we need to manage this reactive power in an efficient way and this is known as reactive power compensation. There are two aspects to the problem of reactive power compensation: load compensation and voltage support. Load compensation consists of improvement in power factor, balancing of real power drawn from the supply, better voltage regulation, etc. of large fluctuating loads. Voltage support consists of reduction of voltage fluctuation at a given terminal of the transmission line. Two types of compensation can be used: series and shunt compensation. These modify the parameters of the system to give enhanced VAR compensation.

1.1 REACTIVE POWER
Reactive power is the power that supplies the stored energy in reactive elements. Power, as we know, consists of two components, active and reactive power. The total sum of active and reactive power is called as apparent power.

In AC circuits, energy is stored temporarily in inductive and capacitive elements, which results in the periodic reversal of the direction of flow of energy between the source and the load. The average power after the completion of one whole cycle of the AC waveform is the real power, and this is the usable energy of the system and is used to do work, whereas the portion of power flow which is temporarily stored in the form of magnetic or electric fields and flows back and forth in the transmission line due to inductive and capacitive network elements is known as reactive power. This is the unused power which the system has to incur in order to transmit power.

Inductors (reactors) are said to store or absorb reactive power, because they store energy in the form of a magnetic field. Therefore, when a voltage is initially applied across a coil, a magnetic field builds up, and the current reaches the full value after a certain period of time. This in turn causes the current to lag the voltage in phase.

Capacitors are said to generate reactive power, because they store energy in the form of an electric field. Therefore when current passes through the capacitor, a charge is built up to produce the full voltage difference over a certain period of time. Thus in an AC network the voltage across the capacitor is always charging. Since, the capacitor tends to oppose this change; it causes the voltage to lag behind current in phase.

Ask a New Question
*
*
*
*
*

Plagiarism Checker

Submit your documents and get Plagiarism report
Check Plagiarism

Related Questions & Answers

Chat with our Experts

Want to contact us directly? No Problem. We are always here for you

TOP

Connect on WHATSAPP: +61-416-195006, Uninterrupted Access 24x7, 100% Confidential

X